SmartLife LED Szalag
Wi-Fi | Hideg Fehér / Meleg Fehér / RGB | SMD | 5.00 m | IP44 | 2700 - 6500 K | 960 lm | Android™ / IOS
Jellemzők
• Piros, zöld és kék szín áll rendelkezésre, de meleg fehér és hideg fehér között bármilyen árnyalatot is választhat - a hangulatának megfelelően
• A szalag lerövidíthető és meghosszabbítható - a végtelen számú lehetőség érdekében
• Kétoldalas (3M) ragasztóval van ellátva - a könnyű felhelyezésért
• Különálló intelligens világításként működik - vagy más SmartLife termékekkel is párosítható, ezáltal teljes intelligens otthont hozva létre
Mivel ez a LED-szalag magában foglalja az RGB színváltást és a meleg és hideg fehér LED-eket is, amellett, hogy bármilyen színt beállíthat, meleg és hideg fehér fényű közvetett világításhoz is felhasználhatja.
5 méteres hossza lerövidíthető vagy hasonló LED-szalagokkal meghosszabbítható, így biztosítva a lehetőségek végtelen tárházát.
A gyárilag felhelyezett kétoldalas ragasztónak (3M) köszönhetően bármilyen tiszta és sík felületre könnyen rögzíthető.
Csomagolás
A csomag tartalma
RGBW LED-szalag (5 m)
Wi-Fi-s vezérlő
Tápegység
Gyors üzembehelyezési útmutató
A kiskereskedelmi kiszerelés méretei Ajándékdoboz eurolockkal
Szélesség | Magasság | Hossz |
---|---|---|
50 mm | 190 mm | 185 mm |
Logisztikai méretek:
Csomagolva | Szélesség | Magasság | Hossz | Súly |
---|---|---|---|---|
1 | 182 mm | 50 mm | 210 mm | 420 g |
8 | 195 mm | 245 mm | 420 mm | 3720 g |
32 | 410 mm | 440 mm | 510 mm | 16000 g |
A termék műszaki adatai
Szélesség |
151 mm |
Magasság |
8 mm |
Mélység |
5000 mm |
Súly |
310 g |
Bemeneti feszültség |
220 - 240 V AC 50/60 Hz |
Maximális adó antenna nyereség |
2.5 dBi |
A következő típusokkal kompatibilis: |
Nedis® SmartLife |
Csatlakozó adapter kábel hossza |
1.50 m |
Maximális adó erősség |
16 dBm |
Színvisszaadási index (Ra) |
80 |
Fény szín |
Hideg Fehér Meleg Fehér RGB |
Az alkalmazás elérhető: |
Android™ IOS |
IP-védettség |
IP44 |
Maximális energia felhasználás |
15 W |
Csomagolásban lévő termékek száma |
1 db |
Dugasz |
Euro (CEE 7/16) |
Állítható fényerõ |
Igen |
Lámpa névleges élettartama |
20000 h |
Támogatott kábelnélküli technológia |
Wi-Fi |
Vágható |
Igen |
Energia felhasználás 1000 óra alatt |
15 kWh |
Anyag |
Szilikon |
Rögzítő |
Felületre Szerelt |
Bővíthető fény csík |
Igen |
Adó frekvencia tartomány |
2412 - 2484 MHz |
Eszköz táp bemeneti csatlaakozó(k) |
DC |
Szín hőmérséklet |
2700 - 6500 K |
Energia osztály |
F |
Névleges fényáram |
960 lm |
Szín |
Többszínű |
Kábel hosszúság |
5.00 m |
LED Típus |
SMD |
LED modul |
SMD 5050 |
Méterenkénti Led-ek száma |
90 db |
Segítség
Gyakran Feltett Kérdések
A következő angol nyelvű kérdéseket találtuk Önnek
Can the strip light up in multiple colours at the same time?
No, the LED's are not individually addressable.
My LED strip does not want to install with the EZ mode installation.
Please try the AP mode.
Make sure that you use a 2.4Ghz wifi network.
Reset the controller so the LED strip blinks slow. (press and hold the button on the controller)
If it blinks fast, reset it again and it will blink slowly
In the app:
+ > [your device] > tap on EZ mode and select AP mode > confirm it was reset > fill in the info of your wifi network > follow the steps in the app.
Hold your phone very close to the plug during the installation
This method uses a direct connection to the device to send the info of your wifi to it.
Holding it close optimises this connection
Can I just take the adhesive strip off?
Ensure that you only take off the plastic protection and not the entire adhesive strip.
If you remove the whole strip, you will not be able to stick it to anything.
Can I extend the strip?
Yes, you can purchase another set and plug the second strip in the first one.
If you extend it to 10m (5m extra) then you might see some loss in brightness at the end of the second strip.
We recommend you install multiple complete sets and group them in the app.
Now you can control all of the strips as if they are a single strip without any loss in brightness.
Can I give other people access to my Smartlife devices too?
Yes you can.
Each person needs a unique account on their mobile device.
To add them as "family members" follow these steps:
In the main screen of the app tap on the name of your home (top left)
Tap on Home management
Tap on the name of your home again.
Tap on "add family members" and fill in the account details of the person you want to add.
It will give them access to all the devices in your home as a normal member or admin (you can select this)
If you only want to share a single device in a home, go to the settings menu of the device and select "share device" -> add member.
My Smartlife products lose the Wifi connection every time.
This is probably a Wifi problem, this can be for various reasons.
1.) Wifi signal is unstable.
2.) Wifi signal is too weak.
3.) Using an access point with the same SSID and password that do not support the IEEE 802.11R standards.
Problem 1 can often be solved by restarting the router.
Problem 2 can be checked with an app Wifi analyzer with this the signal can be viewed and corrected to a better position.
Problem 3 can be checked as the access points are turned off, the Wifi signal is still good and the connection remains if the access points are a problem, a Mesh solution can then be used.
Please make sure that they support IEEE 802.11R standard.